How to make a cheap and fool proof yabbie trap

My father-in-law has been at it again. This time with a you- beaut yabbie trap.

He says; "This little shrimp or yabbie trap has always worked for me."

Here's the instructions:

• Find a length of 100mm PVC pipe around 500mm
• Cut a hole approx 90mm x 200mm to access bait and yabbies (Wal uses an angle grinder)
• Cut lid section from another section of the same size PVC pipe, approx 300mm long by 250mm round
• Cut slots with angle grinder as in photo to allow water to drain
• Cut funnel section from plastic drink containers and cut thread section off funnel piece
• Drill holes through funnel and pipe to tie in place with twine,copper wire or cable ties
• Tie the spring section of a rat trap in bottom of trap
• Attach long length of rope (as per photo) to trap. A float attached to rope is also a good idea if rope should become untied from the bank
• When travelling a piece of sunlight soap is excellent bait, an old fish head good also

Cheap and ready for lots of shrimps and small yabbies